I am an electrician and have owned 52 boats and I can tell you for sure always leave the chargers on. That is what they are designed for. You do...
The cummins is a great engine. With proper maintenance it should easily go 3 to 5 k if not more. 370 is a good size for that boat. I've had 2...
We bought ours a little over a year ago. We lucked out. It was fresh water only from the Chicago area, out of the water 5 months of the year and...
I have a 99 450. You will love it. Best boat I have ever owned. And I've had 52. It rides good, handles good, after you get used to the delay in...
I'm with you there. My 355 was a fast, efficient, comfortable boat. Yes, a pita to work on. My 450 voyager is more comfortable, a little slower,...
You think that's bad, I had a 355 with cummins deisels. Talk about tight. Our 450 is a dream to work on. I had the boat for 5 years and never...
I had a similar problem with my raytheon autopilot. The wife had set a crock pot next to the flux gate compass and it went nuts. You can't have...
I can't speech for the 3206 but my 355 and 450 both had windless installed at the factory and boat had the cables ran right down the v in the...
You can't beat golf cart batteries. I like trogens but they are all decent. My 355 had a weird setup. It had 2 engine batteries for 1 and 2 engine...
You will need to run it down the port side of the arch. Remove the storage compartment on the port side of the bridge. You will see the race where...
Call carver and give them your hull number. They are great. They can tell you the size and manufacturer. And give you the number.
Ok. Now that you mention that, that's probably your problem. Mine did the same thing. The chain locker is too short and it piles up and the...
Mine had 4 20 gallon tanks. Two in front and 2 in the rear under the floor next to the bed.
There is a clutch you can tighten down to grab the capstan harder or loosen it to free fall. You might check that.
I had a 355 that did that. I would describe it as more of a wine or squeal though. It was the cutless bearing. I had it replaced and it quit for...
I had a 97 355 with250 Hp cummins diesels it had 20 22 dyna quad props. With a clean bottom and half fuel it would do 26.5 mph. I usually cruised...
A little update. I talked to a cummins tech today. Told him what was going on. He told me I am running against the governors. He said the...
Carver told me the published speed was gathered on my boat since it is hull 1. Also most all 450's had the 450 cummins engines. The same that I do.
Actually the 2 inches was across the board front to back. Of all 4 I measured , weather it was higher or lower than mine, it was pretty well the...
I am the 3rd owner. When I talked to carver, they were very helpful, they told me this boat I'd hull #1. They said it could be heavier than the...
