Soundown padding went underneath our new carpet. It has made the salon noticeably quieter. We used the 1/2 thick to have it align around the edges...
If you look carefully there is still work to do...
In addition to the drive line change was there a horsepower increase with the pods?
You can see the one in my boat just to the right of the fuel filter. [ATTACH]
Me too...
We explored both synthetic and the real thing for the cockpit in our Ocean Yacht 46. The coaming is already teak. Estimates were $9k for synthetic...
cleanslate, really good point. I will pull and replace a few as suggested by CR to see if I have an issue. Also, I don’t know the material used...
PacBlue and Captain Ralph both correct. Final assembly seems correct with bronze screws, wagers and nuts. The top pin is back n place as a fail...
Below is a picture of the component being dry fit. I decided to use the G10 for the backing plate since the hull was rough and bonding it to the...
The rudder ports were cleaned up like new. The indentation for the rudder port below the hull was larger than the bronze flange so... The...
[ATTACH] The hull where the rudder mounts is solid fiberglass about 1.5 inches thick. Seems pretty substantial though I don’t really know....
A single Seakeeper 6 works fine on my boat with a single 10kw genset. Even with water heater, ac etc on during startup. I sometimes start the...
I like to use the radar overlay to verify the position of marker and bouys. Especially in places with cross channel current with low visibility....
Do impellers bought as spares have a shelf life by which you need to install or throw them out?
Buck Algonquin has a bronze backing plate that seems to be a good fit for the existing rudder posts. The boatyard guys are recommending using G10...
Agree with Pascal, though I do use the shore water hose connected to the cockpit wash down with a pressure reducer to quickly flush out...
I need to replace cracked center front panel currently ez2cy. Got a price using polycarbonate which I read online often has distorted light...
When the yard was prepping for bottom painting they removed the screen and blasted it in their shop, not sure if they used sand or something else...
Picture of the external strainer for the engine on my Ocean [ATTACH]
Good advice. Though my only access to the inside of the tank right now is the sender hole.
