Thank you! Makes sense know. Going to be fun fishing out the float.
I pulled the sender. Can’t figure out how it works or find anything like it on-line. Please help me identify it or recommend a reliable...
There is also an access panel at the foot of the v-berth. Good to know if one ever needed to access pipes at the front of the water tank or rerun...
Found it! We are replacing the carpet next week, pulled it up and found the water tank immediately forward of the forward bilge access in the...
Perhaps install the new one somewhere easy to access and leave the existing one in place disconnected
First, thank you all for the advice, made it much easier for me as a first time sportfish and diesel owner. Definitely an educational experience...
The PMY review and performance test on my 2007 Ocean Yachts 46 were done using 28x38 props. Now a 2” pitch reduction to 28x36 seems to be nearly...
Boat is running well now. Both engines turning up just below 2350 rpm at 98-99% load with nearly full fuel, full water, all our stuff and a lot of...
No manual for the boat itself. Wish I had one.
Figured I would ask before starting to make holes looking for the water tank. Really looking for the sender that’s not working. Tried following...
I will have them check bulletins. It was comforting that was a likely cause on PacBlue’s list. Interesting you mention starters.... Heard the...
The issue seems to be the paper gasket between the charge air cooler and the intake manifold is leaking air. The lack of boost puts the engine...
MTU tech is coming Monday
Now that’s a checklist! I will look at what I can and use it with when I can get the MTU tech down to the boat. Thank you
Thank you for this info. I am going to check it again and verify gauge is reading psi.
Yes. Used the backup controls. I don’t know how to advance the main electronic controls in neutral. I will check again next time I am on the boat.
Thanks for the prompt to update and the suggestions from everyone. The fuel filters were new in May at 1061 hours now at 1158 hours. So about...
On our last trip from Scituate to Nantucket my port engine would not rev up over 1500 under load. This occurred the first time after running for...
Really appreciate all the advice. The picture really helped. Seems like the pins have to go. Only use for the high pin would be to hold rudder...
It would have to be an epic fishing trip to come close to replacing the fuel load. It could be done I am leaning towards a full clean and...
