Great info..... Thanks again for all of your help......my props are 23 x 24 and the trim tabs measure 42" x 9". According to the diver they...
Thanks again Interesting info.........I will look for a reputable prop shop in Seattle.....any recommendations ?? and check out that angle....
Diesel check I did have a Cat guy run through the motors and under a load they ran 2800 rpm....just what the specs recommend. I always...
Trim.... I had the trim tabs checked by a diver last week....They were both moving up and down....the divers comment was that the cylinder is...
440 speed I have cat 3116t. 300 hp .....max rpm is 2800 rpm...... Cruise at 2400 rpm is giving me 12kts fully loaded.....a friend has an older...
In the spirit of trying to get my bow down at cruise speeds ....12kts or so ....on my Carver440, I am contemplating towing our tender ( 11' rib...
canvas back on and fine The canvas shop put the enclosure back together last week and it is good to go....they used 303 water proofing and it is...
A diver checked them out..... OK, I had a diver take a look at the trim tabs yesterday. He said they were moving up and down accordingly with...
thanks Thanks for the reply...........One thing I did notice what was that when the trim tab switch was held "bow up" it seemed to have a...
more info I found the motor / pump under the main stateroom bed.......the motors were in fact working and the fluid was transferring as it...
Location of trim tab reservoir / motor One more thing,,,,,,I was told the pumps / motors are located below the aft stateroom bed.......does...
Thanks Thanks for the reply.....the boat is a 1994 Carver 440 Californian.......I'm going to look into it further tomorrow..........always...
I had some engine work done recently (heat, exchangers and general service. Since then my trim tabs don't appear to be working. Probably...
I just had a new bridge enclosure completed with subrella fabric along with new eisenglass.....The seams leak quite a bit and the installer says...
Thanks Thanks for the info .....any particular sealer you recommend?? I've been using 3m. 4000 or 5200. ??
Windows I checked my windows....the aft windows in the main salon had frames that could be removed by unscrewing the outer portion, but the...
Thanks again Thanks again ,,,,, I will look at the windows tomorrow ....you have a great help ....I'm glad to hear there is no wood backing for...
Rb480 Thanks..... Do you have a 440???? What year???? My frame itself gathers water outside as well as inside. I cleaned the track drains. It...
I'll check it out .... Thanks for all the input....I'm heading up to the boat tomorrow and will look at the frame. My thought is that the leak...
wood in hull I did call Carver. The person I spoke with said that he wasn't sure but he thought the bedding for the screws for the window frames...
