Note that the "Y" valves are zip-tie locked with the waste going to the holding tank and the direct overboard sea cocks are closed. [IMG]New...
I hope these are not too large. [IMG] [IMG] [IMG]
I had disassemble the holding tank evacuation pump plumbing to find out why it would not evacuate. Installed a new pump and cleared the...
I took it to a radiator shop for cleaning, which cleans the coolant side better than I can by myself on the boat . It's a muriatic acid wash...
Tax law aside one can make quite a tidy sum working commercial instead of on yachts for a recent academy grad.
Why don't you use your ticket for 10 years and then buy a yacht? If you are a recent grad of one of the US maritime academies you should have...
Gen set cooling system service time and I installed a new raw water pump, new exhaust elbow, new thermostat, drained the coolant and flushed it...
Anything can be done with enough money, time or knowledge. Deciding if it's a worthwhile endeavor is another matter...
Is this a single bottle in the engine room? If so it's "armed" all the time in that if there fire in the ER then the bottle will discharge. It...
I'm sure it's just as effective as it's the same basic contraption. However when used upside down it scares off the burrowing owls...
lol... literally thousands of techniques have been tried, especially when the seagrapes are in season- all the boats have some amount of purple...
What was posted is the down under version of the Gullsweep. Commonly seen on Sportfish in south florida; no one buys the Ozzie version that I...
Do local auto tint businesses have this for install?
google "motorboating" for some funny links...
all odors, and it smells like a clean place- certainly no stronger than a swimming pool might smell.
Putting a small amount of crushed chlorine tabs into the A/C condensation drain pan clears odors. Doesn't solve the reason why it smells but...
Yeah I don;'t know anyone with a DD that is running anything but 40wt. Shella Rotella or oil from DD.
If you use a propsmith to install the wheels and you have lapped them and previously "blue" tested the taper they should not come loose; the nuts...
Good luck. Nice to see others having 4K hours on a 92. Was there anything you can think of which may have prevented this failure?
Are the props loose as well or just the nuts?
