+1 to all of the above.
Yes I got it and replied to you. Thanks Ken. I'll clear out my PM box.
In some cases the complete "wet" end of the pump will just slide off the motor shaft after you unbolt it from the motor. In others you have to...
The only red I see near the "roof" looks like it's a red lifting bladder or bag. I'd say an blood would have been washed away. If there even was...
CPES over coated with Bristol makes for a nice long lasting finish. http://www.rotdoctor.com/products/cpes.html...
It depends on what water your tanks are made of. Chlorine is not good for aluminum tanks. So it's better to filter it out as the water goes in....
Anybody ever used them? If so impressions? Likes, dislikes, problems? http://02e8226.netsolhost.com/marine-computer-monitoring.html
Listening to that girl who introduces him is painful.
That seems like stupid money for a Ford repower. A lot of it must have been in the electronics. Which you don't need for those engines. And...
Wasn't implying you would get any more speed or efficiency out of the Fords at least. Although you might. I was recommending them because they...
Things can be kept up while on the hard. But I'd be more inclined to go with either the limited charter route or have a qualified and vetted...
The others may be right. But I'd at least look at the cost of a pair of American Marine Ford diesels. http://www.amerdsl.com/ By the way,...
+1 But I think you are asking where one might considered keeping a boat in the Bahamas? If so, you have to factor in hurricanes. So I would...
You should look into getting another A/C tech.
Or if compressed air is not handy use an electric stapler. You can find Monel stables for them pretty readily.
I've heard of it for much larger vessels. But never for something that size. Is this some kind of a last resort?
Yes you put it right in the bucket. Or at least I have. You can also use this system to clean out heat exchangers without removing them from the...
They are not self priming. As far as using acid to clean out coils goes, while I've used it for years in the past with no negative results, there...
What size and type of vessel? I haven't been in Ponce in quite a while (last time was on an 80' that drew less than 5') but the SeaTow captain...
Changing out fuel tanks can be very expensive and be a major PITA. It often involves cutting the boat open on the sides or bottom. Or removing the...
