A lot of people fail to realize just how much torque is put on a rod holder if you're fishing the boat, or if you stick that shiny shorepower...
I would say check the pump sensors?
Stainless I do on an as needed basis. Depending on the type of stainless, if you see a few pieces getting surface corrosion then I'll generally...
If you put a coat of Collinite insulator wax on your stainless after metal waxing it, it will last 3x longer between having to polish it.
"I say again, with proper planning and design plus good build supervision in the yard, you will get a lot of fine boat for your money. But only...
www.awlgrip.com click on care and maintanence. Awlgrip new or old should never be compounded or waxed, at a very last ditch resort would you...
I haven't been on any of the newish ones, newest I've been on was probably a 2008, I honestly don't think things have changed that much. I work...
Very average.
I've seen it in the maria contracts here and there, and I think that's their lawyer who drew up the contract to keep them becoming liable for...
Overall I like Collinite fleetwax. I've found that certain manufacturers gelcoats do react better to other wax such as the 3M with scotchguard....
I'd replace all of the rams. They're not that expensive and if 1 goes, the other ones probably aren't that far behind it.
Did you put the trim tabs down at cruise speed? Boats like the one you bought will commonly pick up a few more knots by trimming it properly with...
Or if you pay cash for the boat, you don't need insurance at all. Scary thought.
It usually stays the same but can fall if negotiated. Problem is, if you cut the commission it can also cut exposure. Generally there is always...
Guys, let's get back to the OP's normal thread "Brokerage fees to company"
Sure, you just eat a 5 gallon bucket full of them and then capture the methane gas you produce, which can then be burned for energy.
I wouldn't be alarmed if it was 100 rpms.....but 400 rpms is typically 8" of pitch too much. That's excessive and there's a serious issue going...
You can have them made and they will look exactly the same and not cost all that much
You have a serious issue going on if you're short that many rpm's and the bottom is clean. You either have major issues with the engines not...
That looks to be a very needless backdown as the reel is almost full of line. Also a huge distraction for the crew that are trying to catch and...
