That is the oil that you need to use for the common rail Man's and is recommended by Man. If you've been running normal oil in your 820s for 18...
Yeah, but you could also keep moving as far as New York with the hurricane on your heels the entire way. Pascals move worked out very well from...
I cannot understand how a 92' motoryacht does not have a full time Captain. The work load of maintaining it, justifies at least 1 full time...
It's reaaaallly sad, what used to be drama free, easy and calm and fun to do, the ICW. Has now become a hair raising adventure where you're...
I just did the Intracoastal PRIOR to the Hurricanes from VA to Stuart,FL. There are several very shallow areas from NC to the Florida...
Wow, that one is a total loss. I think it was a nice boat before it sank, but not sure.
Rule makes a new small pump with a very low pickup that's supposed to keep bilge water very low. It turns on at 1.3". But it's that stupid...
Yeah, I manage a 2007 boat that had them installed back then in 24 volt. They were like flashlights. The new owner traded them out for the newer...
Yanmar has had 28 hp diesel outboards for decades. I've never once seen one here in Fort Lauderdale
6-71 TI's are great motors and most people see 10,000 hours before rebuilds on them, usually 5,000 at a minimum. They're not as clean as the 4...
They're designed to run at cruise, this is what the D.D. dealer will tell you. But, if you want to run them slow (1000 rpms or less), then run...
That is the most annoying part. I too have had to deal with vendors where you're constantly calling them in order to get an answer. Multiply...
That is why I am so successful. I am honest and tell the owners I work for exactly what to expect. I have been using the best contractors and...
If you run them at cruise every 6 hours for 30 minutes they should be fine.
While far from ideal, you could Y both pumps into the same discharge hose with check valves if you had to, I'd find this superior to just having...
I would NOT trust repairing the block with a hole in it. There will be other damage to the block such as the crankshaft galleys if it threw a...
HULL, not hell. Typo....... the hull juts out about 5" about 8" above the waterline and stays that way to the rub rail. Just like a lot of the...
Thank You. While a rebuilt 12v71TI will go darn near forever, if you're going to cut a hole in the boat to get one out. It might be best to go...
Well, you're talking about a boat that was built 36 years ago. None of the people that worked at the factory are still there, and most of them...
I get very good prices on parts and systems from Beard but will not let them service any of my management yachts for the reasons mentioned. My...
