This. Check your piping size, but on the size of your yacht 5 tons a chiller sounds pretty light.
I have cleared in Atlantis many many times, and usually it's pretty quick, around an hour for them to show up. However a few times, I haven't...
That is a very long day, for a day mate. Do-able IF everything goes perfectly, if not you're spending a lot of money on plan B. The trip,...
A smaller diameter prop would probably have a good effect on reducing vibration if it can still get the boat up on plane.
If it's a problem across the entire line, it is most likely improper propeller blade tip clearance. Another builder had this problem, and they...
If you fix junk, you will still have junk. If they're 10 years or older, replace, because you will spend 50% of the cost of a new one and it will...
Is your running gear all in good condition and your bottom clean?
I would put new Dometic's in. I don't mess around with any off brand units. That being said your failure is extremely strange. But, I've seen...
If the boat/yacht hasn't sold on either yachtworld or boat trader, than it is simply priced to high for it's condition. Something is worth what...
I don't know if cleaning them in this manner would help or harm. Detroits do run dirty after periods of slow speeds and cleaning the aftercoolers...
This particular boat is a used boat that had no stabilization. The boat is current production and can be ordered with seakeepers from the factory...
You can use actual fiberglass resin and mix it up with the micro balloons. Or West system. Your plan is solid, but you may run into an area...
I run a lot of Hull #1's for several manufacturers. So I see it all. Yes, I get that, but in this case, it took 3 units to achieve the desired...
You leave the drain plug out. Actually I leave the plug out ALL of the time when it's on top of the platform......One big wave over it and...
A friend of mine had another brand of gyro's put into a sportfish, they did all of the calculations all of this stuff, they promised a certain...
No, Marine Tex gets hard but I think it still has enough flex that cracking shouldn't be an issue. You mix the resin with hardener and then the...
By the way, say the name out loud.....Cialis...…ie Sea Alice..LOLOLOLOLOL
Yacht is pretty rough. It is owned by one famous owner. I don't think you could say it's a party yacht as I've only heard it was around 6 guests...
Just mix up resin and micro ballons and seal all of the holes, re-drill, and put new screws with 5200 to bed them. Marine-tex would work as well...
I'm not a pilot, but on many commercial flights I feel and hear the pilot use the reversers on landing.
