Have you been running bio-cide to keep fuel clean? Once it gets algee may need to have fuel and tanks cleaned?
Seller noticed RPM on one engine was low when brought to a yard for bottom service, so it was adjusted. Then he noticed other engine was low when...
We didn't buy the boat for other reasons. One engine was up to RPM, other being worked on when we bailed.
When one of the 6-71 TIB powered boats we looked at had low RPM the mechanic came and re-set/timed the injection racks.
Thanks I have had an ocscillating saw in use for years. They are handy.
I thought about one of the snake-bite couplers. I would need to get acess to drill the hole in the floor larger for a coupler, it is barely...
The water line to the bar sink in the stbd aft corner of the salon has developed a leak. It is right where the line passes through a hole in the...
Our boat I believe has a slightly different trim attitude than other Posts due to the CATs being 1200 lbs each lighter than the Detroits. Our...
Not 43 but there is a line drawing you may be able to modify on the 42-47 Owners manual. [ATTACH]
We've run Prop Speed on propellers for two seasons now with very good results. Plan to add it to the struts and rudders next season.
We have a bit more power, 500HP Cat C7.1's. RPM isn't useful since I have higher RPM engines. That noted, we cruise 23-24 kts at 70-75% per...
Last weekend we ran in quartering following sea a few hours down the bay and quartering head seas coming back up the bay. Roll was almost non...
Thanks for the info. I've had problems at Chestertown, and times when it worked fine.
Possibly what I need is to make a short chord I can plug inline at my dock with the separate wires accessible so I can check with a mA loop...
My clamp meter claims to read below 1mA but the only place I could use it to capture a line and neutral is the split behind the show power...
C team - I've been told by my boatyard the isolation transformer route is less than the labor to try to locate, and then fix/replace wiring in...
Capt Ralph wins the Cupi Doll (typically he does). Doing a bunch more isolation testing it turns out that when the air freshener, which does...
Unless my math is wrong: The new shore power pedestal trip limit is 30 mili amps, .030Amp. At 240V that is a resistance of 8000 ohms. Any...
I found and fixed issues before where there was a continuity between ground and neutral. The DVM says there is no continuity between ground and...
I'm trying to investigate a shore power isolation transformer installation requirements. We only have problems tripping the new power posts at...
