Cick to Clean Black Water Click for Perko Click for Northern Lights Click for YF Listing Service Click for Westport

Roamer Cruise Control (trim tab) and CAPAC wiring

Discussion in 'Chris Craft Roamer Yacht' started by CCRoamer46, Jun 12, 2022.

You need to be registered and signed in to view this content.
  1. CCRoamer46, Jun 12, 2022
    #1
    CCRoamer46

    CCRoamer46 New Member

    Joined:
    Jun 12, 2022
    Messages:
    1
    Location:
    Required
    Hi.
    My 46' aluminum Roamer has the "Roamer Cruise Control" trim tabs, but at some point all the wiring for them was removed. The actuator motors work fine and the rheostats rotate as the shaft turns. The switches, lights, and gauge at the helm are still there, but all the wiring for them is gone. If somebody could snap a high def picture of the wiring at the actuators and from the under-side of the helm dash pod, I'd really appreciate it.

    I also have the transformer and gauge panel for the Englehard CAPAC system, but all of those wires were cut. There are no hull electrodes attached, but Evoqua tells me they still sell those. Pictures and/or descriptions of where the wires go would be great!

    Thanks