Plus 1 on the exhaust elbow, impeller inter-cooler and heat exchanger.
oops, my bad
Capt Ralph: Two thoughts, It appears to me the most likely problem would be the in fuel sensor reading too low ( clogged with algae, bad bearing)...
Make sure you get deep cycle batteries, a starting battery does not work for more than a short time in this application. From my experience you...
I run 4 flooded cell 6 volt golf cart batteries rated at 220 amp-hrs connected in one series parallel bank. Many battery experts will stay to...
I'm a big fan of 120 v refrigerators (cheap) and inverters. The last two boats have been set up this way and it works for my style of cruising....
I had the same issue. I replaced both of my alternators and one stayed at a cool temperature and the other would warm up and kill the battery....
On my OY 44, 1987, the holding tank is in the companion way under the floor board between the main stringers.
If the IR gun confirms the 160 reading on the port at 1950, then there is a problem there. Probably the thermostat is not closing.
Sure you got the water tank? What does the water gauge look like? Perhaps the sender is capacitance or vacuum.
The tag on the box says refrigerant 12, charge 12 oz, tested at 150 psi and good for range of 10 to -10 degrees F.
Great look 46
Wdrzal: I lowered the thermostat and got the temp in the freezer box down to 10 degrees F. I was satisfied with that data point so I adjusted...
Congrats
I determined that the freezer had some Freon still in the system. I added about 3/4 of a can of freeze 12. The site glass shows no bubbles and...
Congrats, you'll be happy.
All good info, thanks again. The Johnsen's Freeze 12 arrives tomorrow and the sniffer on Monday, should have some results mid next week.
Great idea, got one ordered! Will post some results in about a week.
It is a Cruisair unit, probably original, boat is 1987 and tag on unit states R12, The unit was used last May on a long trip but noted was...
My unit is definitely an R12 unit, I found a replacement Freon, Freeze 12, got it ordered. Supposed to be compatible with R12, evacuation not...
