As Dockmaster stated, you need to track down the low voltage issue first as it will have issues with the computer/electronics. After verifying...
I've read that manufacturers have orders reaching two years out. Sales are still up 20% over pre pandemic but down 20% from 2020-2021 pricing. If...
Welcome aboard. Question, could you be sucking air? The high temp alarm comes on at dock or while running the boat or both? Can you see the water...
I would swap temp sensors between engines and see if the alarm follows the sensor. Could also be a bad computor. Swap that if the engine still...
Welcome. Have you checked the hoses and manifolds with an IR temperature gun to see if you are overheating? Verify temp between both engines....
Last boat I purchased was New, put no money down, deal was dependent on a satisfied test drive, boat performed as per specs for boat handled...
All great information.
Have you verified that balance is not set to all right stbd speakers? It is possible that the left port channel went bad.
I always install a filter in the small pressure line it will help if a compressor goes bad to capture debree.
If you clean it well, no primer is needed. They do have a clear primer. I've used the paint on plastic with out primer and never had an issue
Krylon pant is good on plastic, other wise Sems paint for vinyl found at some auto stores and Amazon, we used it on vinyl dash board, door panels...
TDS does most of the work for OEM Manufacturer's, Hatteras, Chris-Craft ect
I was on the beach waiting for the launch, we could see Harmony off to the south just sitting waiting for the launch at the same time the MSC was...
Tader2112 profile states from New York. So in the US. What are you looking to use the boat for, LI sound, ocean. Can you tell us what your wants...
Sounds like they all got paid off to allow this, Tammy Duckworth is a real peace of work in Illinois, part of the corrupt government in IL, I know...
U.S. Senators Introduce GPS Bill decision in 2020 to allow satellite communications company Ligado Networks to construct a land-based, industrial...
Is the MFG still in business, a call to them with Hull number would be best bet and if they have any drawings to send you.
I'll send you a ransomware, Just to you so you feel special.:eek:
Nothing will a low you to reinstall besides pins. The foam backing is deteriorating and using spray adhesive is going to just make a mess and when...
Contact Crestron, they will go over the system with you, they are highly upgradeable and may already have what you want to use it for. They are...
