Th The latter is a huge problem. I’m in the space business and boats stop launches all the time wondering into exclusion zones because they...
Have you tried a heat gun yet? I’ve never had a lot of luck with chemical strippers, but a heat gun followed by sanding has never failed me. It’s...
I ended up with an AB navigo 12 with a Suzuki 30. 4 blade prop and smart tabs. The main thing that sent me to the AB was the deep v of the...
Mine were all mechanical as well with no floscans or anything. I logged every RPM I ran at and for how long. Then I totaled up estimated fuel...
Very interested to hear how it does on one of those 3-4’ nasty wind chop days on the bay. Price sounds super reasonable relative to the benefit....
This is exactly the opposite of everything I know about the typical Viking vs Bertram approach to hull design. Bertrams typically carried their...
I had it propped to make 2350. Id run it up to WOT briefly a few times a year to make sure everything was ok. Seems like it was about 29-32kts,...
I had a 98 58 with v12 1200hp mechanical mans. The 50 with 1100s should be a rocketship but seems like the engine room would be tight to the...
Interesting so she applied it over the original finish? She didn’t strip it to bare wood first? That would be an awfully nice time saver but I’ve...
Later models of the post 42 was available with similar power. There’s a 2008 listed currently with QSC’s. However, the newer models have a...
Some of the wood in my cabin needs to be refinished and I’m trying to figure out how to match the existing finish. It’s a very smooth but also...
Do you have a guess of the pitch? I read 8”-9” in another thread but they were talking about a 3-blade. (Assuming a 360 with a 30hp tohatsu)
Possibly. Part of the problem is that they are only 3.5’ apart. So I guess I could put longitudinal rails on there that extend out a bit further....
Well it looks like the chock question is moot. I measured our existing chocks and the front has an angle of roughly 18 degrees and the back is...
Currently have a 10’ novurania 320 tr with a merc/tohat 9.9 4 stroke. Considering upgrading before we do our first abacos trip this summer to...
Realize you’ve probably completed this job already but I had the same tender with the same motor. Loved it. Lots of fun. Fast boat. Used to pull...
Alternated high pressure water and vacuum through the vent line. System seems to be working now. But I know better than to ignore wise counsel....
Well, good news is I waited 3 hours, tried it again and it flushed right out. Which I feel like seems to point to a slow vent, right? A vacuum...
Started having problems with the control board in my 25-year-old raw water fed Raritan so I just replaced it with a brand new Atlantes. It seemed...
Do you need someone with templates? Can you not remove the existing panels and have them copied? I'm not familiar with what is around you in RI,...
_2.jpg&contenttype=jpeg "Click for YF Listing Service")