I'm away from the boat right now that's the only picture I have on the iPad. When I get to look at it I'll see what it is I can do. You all have...
Behold the above shot of a 31 CABO X aft bildge! Got the photo to upload. The most forward pump is the fish box macerater. Large through hull is...
Admin Edit: This image has been reduced to meet our guidelines.
For some reason when I try to upload a bilge picture I have from the boats survey report it's says the file is too large. My shut off valve...
So how was it sold when new? What was the original set up? Does anyone know? I'm not ready to redesign the boat and add another through hull to...
Even though I've owned boats for 30+ years this is my first deisil and my first non trailer-boat. So I certainly appreciate all the knowledgable...
First pump to activate at the dock in a heavy rain or leak is the most forward pump in the cabin deep V bilge followed by mid only then if water...
Yes 3 separate bildge pumps but only 2 discharge points. Aft bildge is alone, mid and forward are plumbed to a mid ships higher discharge point.
Don't misunderstand me, I will fix it. It's that's this now known problem is a small one imo. Here's what I'm thinking will work for me. I'm...
Exactly, there are two low and aft (3 inches above water line) molded right into the gel coat holes. There very nicely done and hidden in the...
What I'm wondering is how CABO could have sold this boat new? If I had bought this expensive boat and took it for a sea trial and the bildge went...
Ive been searching for a mystery leak and finally found it. When the boat comes off/on plane the aft bildge pump discharge hole goes below the...
Got it, the hose barb should flow static pressure water when the hose is disconnected, thanks Bill!
Capt. J, I understand pulling off the raw water feed tube with the engine running but what is the other thing you check with the engine off for...
How do you guys go about testing the raw water flow? Just pull the hose off the fitting on the seal with the engine idling and let the water run...
Chatfield marine, the BWS builder said I need to check the internal bearing/guild for wear as well as no "run out". This made me think to just...
Decided to do as you did and get rid of the BWS set up and switch to tidewater. Still on the fence about the prop. I'll talk to the prop shop and...
Turns out the lower helm has the wrong switch installed. It a 3 leg switch but it takes power from one leg and switches it to both other legs at...
I ordered and received the switch from glendining so hopefully it's correct. I could try swapping the position of the two wires on the two post...
