Hi, the recent storm here in Northern California was great for many reasons, but it also pointed out a couple of nasty window leaks in our 2001...
Another option (if you're considering a full replacement) is from SCAD. I replaced both my holding and fresh water tank sensors with a TM2 -...
Interesting and thanks for the follow-up. Crazy that they didn't include those instructions when in fact such a specific setup is needed. Going...
Is there a water filter somewhere that serves the whole boat's freshwater system? I had a bad carbon filter on my galley sink that added a lot of...
Are you looking for a 120V / 12(24)V combo, or solely DC? I'm using this pump as my primary and am happy with it. Pretty quiet....
Thanks, CR. Something to consider. Sensors are not expensive and most (except for the exhaust temp) are fairly accessible. Maybe just start...
Two good suggestions, thank you! I do have two of the same generators so I'll first check the HE and then start swapping sensors, one at a time.
One of our Onan 27kw (MDKAF) generators has started to randomly shut itself down. Sometimes it will run for 2 hours before doing so while other...
Great, thanks. And now I know what to call that pump. : )
The pump is a Jabsco diaphragm-style with integrated check valves. [ATTACH] Sounds like I can remove those two extra check valves and improve...
Hi, I've been spending some time refreshing the holding tank on our Horizon 76 MY, including a complete pump out, new dip tubes, new SCAD monitor,...
It looks like they are already connected as they should be for bypass - those are just the grounds. No need to touch them.
To bypass, you'd just need to connect the two pairs of wires like this: [ATTACH]
Okay, fair points on leaving well enough alone. Yes, the paint is looking old inside the dryer but I'll see what can be done with some appliance...
Back on the boat... the transom door is 23" wide if the door hardware is removed. However, the appliance itself is 24" and it's not going through...
Several of my air handlers weren't blowing cold air (for cooling) or vice versa for heating. As Pascal mentioned, many weren't activating their...
Got it, thank you. I'll measure again more closely once we're back on the boat this weekend. I'll let you know!
Yes, that's the transom door and it's well less than 24" wide. Removing the door/hinges will help, though, good tip. What do you mean by "new...
Hi all, not sure where to put this thread so moderators, please feel free to move, as needed. We have a 24" over/under washer/dryer that's 20...
Agreed. I would think that the exhaust will need this raw water cooling almost immediately, long before the engine itself comes up to temp...
