Also, how are your Engine Gas Temps. Those are excellent indicators of reduced efficiency. They should be a logged item so you can detect an...
Do you have airseps? Pull them off, shine a light inside and see if the turbo body is dirty. if you run your finger lightly across a blade and...
Check the same time you check your oil- that should be every time you start them up even at the dock. You'll never know your oil bled out thru a...
. If you have twins you may consider replacing both coolers if that was your problem.
Keep a watch on it, and even if it looks clean after a few runs, I would change it at least one more time with the filter
Depending on how much water is in the tranny you may be able to run a tube to the bottom of the sump and pump it out also. Don't forget to empty...
Doesn't matter any longer - he shut his question down. See#11
Good idea, thx
That option is on the table as well. If I could get an 18" pipe on the handle, I think they would move more easily. Unfortunately the way they...
IMMO, your party should be reading and familiarizing themselves with all the rules governing that license class in his/her intended area of...
I wasn't talking about getting it cherry red, just warm. I'm going to use a space heater or hair dryer to do that, not a torch - 42 degree grease...
All good points
Suppose I put a little heat to it ….helpful to disperse the grease? Water temp is around 44F right now
Pictures probably next week end. To top it off the valve to hose measurement is 2 7/8. Try to find that ! Gotta be metric
I can barely get to them over the battery cabinet, and toward the outside....but I'll try. I don't even have room to put a good size bar on...
Will do. Teach me, why lithium rather than the red water "resistant" grease. BTY, my seacocks are bolted to the hull.
Thanks. I'll try those zerks.
I am definitely at fault on the "exercising" Once a year I open them and then close them - for 20 years. This last season they took a gigantic...
Both seacocks to my Mans take a pry bar to move. I don't know the model. But can these generally be serviced and loosened, or should I expect...
Well Done!
