Yeah , I’ve used muriatic acid from a plumbing supply before back in the day on my Matthews with 6v53s It worked well, but environmentally...
Are the exhaust mixing elbows stainless steel and look new or are they the old cast-iron ones ? Just like Chesapeake 46 described . I replaced...
I think I figured it out, mine are J and T cast tank, not the Cylinder tube type that both Lenco and Sen-dure make. I thought all Detroits had a...
You only have to remove one side, I think it’s the inlet side, anyway it’s the side with the flange on the Sun-dure heat exchanger, then slide it...
Not necessarily you generally have to treat each engine independently in my opinion . when you say cast the only thing that cast is the holding...
I thought Sen-dure was the only heat exchanger made for Detroits, J & T etc. ?
You probably have sea skank in the tank! and else where... I use Barnacle Buster, two gallons and mix with two gallons of water and run that...
Why is there a pin in the middle doing nothing from what I see? What Ralph said , you have to get the load bearing pin out of the way to install...
You got to remove the four old post nuts and bolts , and replace them with new ones the same that came out. clean things up between the rudder...
Ok got that too. YF school is always very informative. Thanks CR I know what FRP is!! Fiber Reinforced Plastic ! AKA Fiberglass..lol. See I’m...
Got it CR ! Thank you. It’s not a relevant thing to have on a fiberglass boat of any size I assume ? Or boat material doesn’t matter ?
Uh...What is a CAPC system?
Darn! Always learn from you PacBlue ! I drive by there Mt Laurel NJ office at least once a week. Never knew about this. I would like to know for...
The Matthews had a lower and upper helm stations ! And lots of heavy old windows with unobstructed visibility all around ! I could go on and on...
With young kids , and people in general. You want your boat to have a safe railed or life line walk around deck. All the sport fish that I see do...
CR ! Yup I used it . my mechanic got it for me I still have the bucket in the bilge for old oil and fuel I’ll take a look and double check the...
Try Arrigoni Design.com, they have nice stuff and I'm sure they could make a custom one for you.
It's Valvoline 40 weight in a blue NAPA 5 gallon pail, btw. I'll give it at try if the price is right. I don't see a difference with any of them,...
[ATTACH]
I just installed two mechanical oil pressure gauge is at the engine . Got them both along with the fittings for $20 each at the automotive store...
