What's up with the spacer? Shaft not long enough? I do hate spacers. How are you sure the spacer is centered perfectly on the clutch output...
Interesting the seller would risk the yachts sale over a non-Rolla prop shop. Is he not conscious?
Any updates? What did you find? How was it fixed? Lots of pictures (we like to watch)..
Horizon, Standard and then Parker kept the System 9 RO system supported for a long while. Seems now that I'm updating my RO requirements, that...
I'm confused, was it not assembled in the shop? Surfaced on your shaft? Re-assembled the same way on board? Same shaft key? Tapered shaft only...
Problem with the Rule pumps, They can never get the last of the water out. AND, the back wash from the discharge hose always returns. You can put...
If it is the adapter plate, please examine the clutch front input shaft seal carefully. Behind this seal is the oil pump. When that seal leaks, it...
I think you are on it... It will be in your hands soon. Share your project and blood lettings, post lots of pictures here.
I am not familiar with the At Sea converters, Are these shore power & ship power isolation transformers? Or, Auto-transformers from the gen-sets...
Older ACv powered clocks run by the 60htz freq. Newer clocks do not. Other than this lil issue, I would not mess with the gen-set to set Htz....
I have commented before that prop shops grind off the diameter when the blades get thin. There is just to much required in the last few inches and...
Ferretti Era Bertram.
If it's a 30, then large boat? Then large boat, a second gen-set?
May-be,, May-be a little un-balanced Volt wise. Without an amp meter per leg, won't know if it's really un-balanced on current draw. Without an...
If you were to take an O scope to the leads, your 121 Vac would look pretty noisy and your volt meter is picking up on the peaks of this noise. A...
Lil different than your first post numbers. Looks damm good. What was your problem again?
Wait, Is this a F E B?
This was what drove me crazy on one job. On another issue, deck to fill sealant failed, top hose clamp rusted away, hose turned into a funnel and...
Mud filters should be 30mic and secondarys around 10 to 16mic.
Pending the design of the pot, this may be the failure. These devices maintain a 4 or 8 ohm impedance on the stereo output. Load the line with...
.jpg&contenttype=jpeg "Click for Abeking")