Marlago.
Cat 360 is the factory option on the 75' Hatteras.
Jeremy at Cutting Edge Engraving in Fort Lauderdale.
That boat has a hell of a lot worse issues than that, with that much algae in it. If you start the motor after changing the racor (which you...
You can have wing stations on the lower deck.......easy peasy.
No vibration, they're 30-40% more fuel efficient than conventional drives on a twin engine installation, smaller engine= easier to get around...
A racor is by far easier. I can change one in 30 seconds without draining it, don't have to fill it with diesel before putting it on and don't...
P+R Canvas does them too. Most canvas companies can do them.
The 76' I ran was different. I think the extra 4' of cockpit made the 80' ride better. The 76' I ran had some trim tab looking plates the shape...
If you don't get water in your primary fuel water separator. Chances are you won't have it in your secondary. The secondary water probes are...
THIS, it's still considered a big 105' when it comes to taking care of it. Towing adds a need for an extra crew member as well. If you don't...
And work load. Why is the aft crew stateroom not usable without a refit? Usually you can make a stateroom usable at just about any dock/marina....
Yeah, AND running offshore would scare the living daylights out of you. I had 2 different episodes in relatively calm seas where we got hit on...
An a/c sea water discharge pumps a ton of water. I know of a Delta over 150' that almost sank right at the dock when it was a few months old when...
Well, define WHERE on the East coast you plan on cruising???? Do you plan on doing the ICW on the East Coast? You can get away with 6' draft...
The Viking MY's are intriguing but have a very different exterior layout compared to typical MY's. Sunseeker makes a very good riding 75' but...
More effective. More ability to mount them in different places than just on centerline.
If you put copper tubing inside of the next size larger cheap clear vinyl tubing (like what you run to an ice maker for water), you can bend it...
Stick with copper for that.
Yeah, pretty much.
