Noise, if it springs a leak, etc. a lot of manufacturers 'put them there. It just is what it is.
A displacement hull has a set speed through the water and will not exceed that speed. It is based on a formula and the hull designer can tell you...
3406's are great engines aside from the aftecooler issues. They are now known as the c18. With the updated aftercoolers they're very solid...
That's simply untrue as it depends on many factors. The faster the vessel the less hull in the water and the less drag that it has and the lesser...
That is not true. A displacement hull has a set speed through the water in which it can travel, it is based on length, beam and other factors. No...
Either you have a bad valve in one of the returns, OR ive seen the impeller or check valve go bad in the fuel transfer pump And allow fuel to...
No not at all, they just continue on from where they left off. The time is getting the gyro to it's rpm.
With all due respect, I run 100-150 different yachts per year in all conditions and types. I do 15,000 nm's a year, each and every year since 2003...
The spool up time is a non issue for sea keepers. All of the yachts I ran where they were a factory install had the shore power to run them on...
Don't be a coward, go to sea on a broward!
In order to have zero speed stabilizers the fins usually have to be oversized and slow you down. I would go with the seakeeper, because for what...
Yes, Zeus was a joint effort between Cummings, mercruiser, and zf. It was owned by CMD, Cummins mercruiser diesel. As far as I know they have not...
Yup, the fitting is just press fit into it.
Why? Because if any issue is going to present itself in the near future, it will present itself at wot now usually
I have this issue with common rails on a yacht I've managed long term. It seems to only occur on the port engine and once every couple of years....
5-10 minutes, 1 minute isn't enough to see how the coolers are doing, speed, rims etc. I know one popular surveyor who does it for 15-30 minutes....
What motors do you have????? Yes it is possible for some gas engines to rotate backwards if they have a camshaft that makes them run backwards....
There is a lot of bad will when it comes to Marlow......build quality, ethics, how reputable the company is, handling. Do a search on here and...
Absolutely. Boats that have shaft wipers don't use zincs on the shafts, so the wipers tie the running gear into the bonding system and transom...
Yes, I have had several tv's framed with wood to match the woodwork so the deepest part is almost touching the wall behind it. Just make sure to...
