2350rpm's
All of the above, as well as the last time I went through there some locks got washed out as well. It's usually May that is the bad month as all...
Did you trim the boat with the trim tabs?
I don't think 98F is too hot for a bearing that's not designed to be water cooled. Does the bearing have grease in it? It seems like it should...
Do you have seawater cooling the p.s.s. bearing? Usually with boats with engines, seawater is constantly pumped through the bearing.
What about a small piece on one side of the bed that hydraulically folds up or down to make the queen into a king? With Memory foam it could be...
Wouldn't you need just as many BTU's of heat in Vancouver as you would air conditioning in Florida? I understand the no dishwasher on a boat that...
Yeah, but the problem on normal sized yachts is you have limited resources (electricity), both from shorepower and generator. If you have large...
The reason Princess and Sunseeker don't have stabilizers (and most of the Euro brands), is there is no need for them. They simply don't rock and...
On a 65' I would rather have the tender on the swim platform, even though it gets soot and some salt spray. Between the weight of the tender,...
I honestly think from a quality standpoint, I'd put Sunseeker first, Princess and Fairline fighting for 3rd and Azimut last. The nagging little...
If you're running at 1300 rpm's, you might as well run at cruise. 1000 rpms or below is considerably more fuel efficient.
The 6v92's are a lot more forgiving than their big brothers. I had an owner start and run one without oil till it shut down (cold start up). The...
Not horrible, just hard labor. Remove the exterior frame if it has one. Carefully drive plastic or wood wedges in and saw away at the butyl with...
The boat is 23 years old and so is the butyl they used to seal your windows, just remove the entire window and re-bed it or you'll never get it to...
With 4 blades (or more) you get better bite for getting onto plane and staying on plane (in some boats that are borderline) as well as less...
I agree, get a good engine surveyor as well. But it says the OP is going to get an engine surveyor and just wants general knowledge.
One thing about the Great Lakes is they can go from nice to rough very quickly, like in a couple of hours. So speed might be of interest and in...
Most people rebuild either when 1 engine fails, or when they show signs of a lot of wear, like smoking out the entire marina on startup. I...
I agree with this as well, 250V 50amp is common almost everywhere. I cannot even remember where I've even seen 125v/50amp. You should have no...
_2.jpg&contenttype=jpeg "Click for YF Listing Service")