Thanks to everyone. In our particular case the pump is surely running on european standard 220V/50Hz, I checked the voltage coming to the pump...
The boat system is 380 v (3ph)-220 v (1ph)/50 hz, the Watermaker is using single phase power supply 220v/50 hz, so I believe even the old pump...
Hello everyone. The question is about Aqua Whisper II Sea recovery 1800. The system was run last time and winterized in December 2018. Then, I...
Thank you for a prompt reply.
Thank you for the replies. To make it more clear: the boat is around 33 m (~100 ft), made of aluminium, the manufacturer, unfortunately, doesn't...
Hello everyone, We are considering the possible installation of Jacuzzi/Spa during refit. Could someone share pro/contras from own experience,...
Do you mean something like Epoxy West System barrier coating?
Hello everyone, I'm reconditioning the Seachest boxes for cooling water intake, so they are always full of sea water. The material is aluminium....
Thanks for advise! The measurements were taken with filler gauges by a diver, while checking/changing the anodes. Unfortunately, I don't have a...
Thanks for your reply and the example on the picture. It's always nice to look at the clean new installation:) What would you say about such...
Hello everyone, Could anyone advise me a reference for the minimum/maximum clearance of the cutlass bearings? Diameter of the shaft is 100 mm....
Thank you for your input. Yes, the shaft is quite long (10.156 mtr long and 100 mm diam). I also think that the numbers stand for the bearing...
Hello everyone, I have 3 cutless bearings on each shaft, which are labelled on the drawing as Cutless rubber 450 LG, 370 LG and 300 LG. Could...
Good afternoon Colleagues, I'm sorry if this question has already been discussed. Can anyone advise about the use of salt for water softening...
Good morning colleagues, There's a need to carry out the megger test, in particular, to make sure that the insulation of the electrical equipment...
Good evening colleagues, Sorry if I post this in a wrong place, I'm still new on this forum. I hope that someone can help me with a following...
Thanks all. Seems, that it works OK now. As Capt J advised, I increased operation pressure up to 850 psi and the solenoid valve actuated....
I thought about it, I let it work for 1 hr and still no product water coming. Also, I guess, that the salinity indicator must show that water is...
Update: When I open the 3way solenoid valve manually by leverage, water normally flows to the bucket, so the problem is in this valve. I've...
Unfortunately, the charcoal filter is not a problem. I've disconnected the filter inlet pipe and put it to the bucket, still there's no water...
.jpg&contenttype=jpeg "Click for Abeking")