In order to have zero speed stabilizers the fins usually have to be oversized and slow you down. I would go with the seakeeper, because for what...
Yes, Zeus was a joint effort between Cummings, mercruiser, and zf. It was owned by CMD, Cummins mercruiser diesel. As far as I know they have not...
Yup, the fitting is just press fit into it.
Why? Because if any issue is going to present itself in the near future, it will present itself at wot now usually
I have this issue with common rails on a yacht I've managed long term. It seems to only occur on the port engine and once every couple of years....
5-10 minutes, 1 minute isn't enough to see how the coolers are doing, speed, rims etc. I know one popular surveyor who does it for 15-30 minutes....
What motors do you have????? Yes it is possible for some gas engines to rotate backwards if they have a camshaft that makes them run backwards....
There is a lot of bad will when it comes to Marlow......build quality, ethics, how reputable the company is, handling. Do a search on here and...
Absolutely. Boats that have shaft wipers don't use zincs on the shafts, so the wipers tie the running gear into the bonding system and transom...
Yes, I have had several tv's framed with wood to match the woodwork so the deepest part is almost touching the wall behind it. Just make sure to...
There probably is a transformer that steps down the voltage and only supplies x amount of watts and either they're exceeding that, or they don't...
All of the ones I have seen and used, the brush has a stud that goes through the bar and a nut on the top side. You can either put the bonding...
I don't think it would be an issue if the mount is a good one. Your best bet is to call LG and ask them. What about flush mounting it to the...
Hopefully NOT their seacocks with a bronze body and s/s handle because those are complete garbage. The handle eats away the bronze stud it's...
What do you mean by Sailing World? If you mean Sailboats? Either of those 2 universities would make you overqualified for most positions in the...
The thinness is no issue, they hold up fine. I prefer Samsung over LG (LG the picture is too dark for my tastes, even if you adjust it). Also if...
Why would you even produce cheaper "display" models. It makes no sense as the laws of production usually mean that the more you produce on your...
Who soldered that tab where the bonding wire is mounted anyways? It can and should be attached where the wiper arm is attached on the other side...
This. I would just install a new one and make sure saltwater isn't dripping on it. I would not put grease on it. Also it should be just touching...
Getting it through most salon doors is the tricky part, without banging up the woodwork or paint.
