Probably just sand it down really good, fill-in/fix the cracks, use the right primer and paint.....your painter will recommend what to do. The...
I would never run anything single handed, ever. Unless maybe a 40' express in inland waters. I have seen way too many variables that I NEEDED a...
I wouldn't just fix the cracks, I'd just awlgrip the entire hull, it should be less than $30k. Then you don't need to pay to wax the hull, just...
I cannot remember for sure, but think the relay has a wire that goes to the seacock so if the seacock/handle is not open, the pump will not pump...
Use superlube grease instead of Vaseline. Vaseline is petroleum based and can effect the rubber seals and duct bills over time.
If it's the last cylinder before the turbo and exhaust riser on all 3 engines and the risers are too short allowing a little saltwater or...
Or a dirty bottom or running gear. After reading your update I'm changing my thoughts. Is #6 the last cylinder of every engine before you get to...
Thanks for the offer, I just literally got home from flying back from Harbor Island. One of these days I'll take you up for it.
also owners add things on the fb or hardtop all of the time that effect the builders or boats initial stability such as freezers, life rafts,...
Aside from the long winded thread about scientific stuff. Olderboater was just trying to get across that the boat handled extremely well in 6'...
If the girls aren't already long gone by the time the Duffy guys get there :D
Do you then give them to your malicious dock neighbor as a gift afterwards?
Check the tach sender. If it's on the flywheel, many times the depth has to be adjust over time. Usually bottoming them out and then backing off...
Call Surfside 3 (Marinemax) in NY, their parts department is quite knowledgable and quite good.
How hard is it to remove the belt? Also if the belt is too tight, it could pull the shaft out of alignment. A thought is to try turning the...
How much does the bearing cost? If it's cheap, just run the thing and see what happens.....
2350rpm's
All of the above, as well as the last time I went through there some locks got washed out as well. It's usually May that is the bad month as all...
Did you trim the boat with the trim tabs?
I don't think 98F is too hot for a bearing that's not designed to be water cooled. Does the bearing have grease in it? It seems like it should...
