I've had a bottom media blasted by Barry Brown Marine and Cable Marine. Both did a very good job and all that was left was the gelcoated...
Look for the a/c return grates. The units are usually really close to them (behind them).
I found that Moore Head City municiple marina had much cheaper fuel than Coinjock one time 60 cents a gallon, but it might have just been a fluke...
Originally Coinjock was known for having the cheapest fuel on the East Coast. When they lost that distinction they had to come up with something...
I have a yacht I manage that the owner wants to replace the thin teak deck with a synthetic teak deck for less maintanence. He currently is...
For some reason this is a hard route to get yachts shipped from. Look through Roger's "Welland Canal" thread as there is a 72' Hatteras being...
I agree and it's been a while, but isn't WOT on 671 TIB's 2800rpms and cruise should be 2250rpm's? If I remember correctly and a slower cruise at...
I've dealt with over a handful of boats that were shipped directly to various parts of Australia. Why ship it to either of the places mentioned if...
If you have continuous rails. I would let passangers go foward if I was doing hull speed and in calm inland waters. Never underway at cruise,...
I've seen many people use a handheld GPS for an anchor alarm.....but it might be difficult to get a sat signal in some staterooms......You could...
Forget that. I wouldn't go in that inlet with anything more than a 17' Boston Whaler!!!!!!!!!
Anything sea water passes through is connected. I even was on a Maiora that had a short on the earth side. You could put the volt meter leads...
Anything that has sea water passing through it and is metal, should be bonded. I have never, ever seen a premature thru-hull or seacock failure...
Well......I'll tell you a funny story. Roy Merritt swore against zincs on his own boat, a 46' Merritt and felt that zincs make barnacles grow...
I like the Guest ones. I had an issue on a yacht where the zincs only lasted 6 weeks, everything was tested on the yacht itself and checked out...
Repairs is his largest expense.........
Sure, I could use a vacation this summer. I'll even pay for the fuel and bring along a dozen or so of my neighbors so you'll have some free...
If the spots are from mold on the backside of the material they will come through the vinyl dye as well. I also don't recommend using the vinyl...
It means that you don't need to worry about a galvanic isolater. To the other poster. You want to trace the green wire from the boats 50amp...
If not they are an easy install and good to have. You just put them in between the green wire on the boat's side of the shorepower wires.
