Finally got the boat trialed after a hard winter and happy to report the rebuilt Trans seems to be working great. The higher temp is gone and both...
Doesn't address your out of stock issue but thought I would add that I installed Sterling 24v to 12v chargers about 5 years ago and they have...
Take extra caution to make sure your splice from the 8 Plait to the chain is correct. I bought a complete Rode from Maxwell only to watch the...
I switched both my starting and house banks to AGM five years ago and couldn't be happier. Starting are 8D's and house are group 31. The house are...
I agree with comments about lapping prop to the shaft. I know the sequence of the nuts has been discussed and debated at length. The sequence can...
I agree with Pascal and don't see the need for a bridle. I anchor in much deeper water regularly and I just make the 8 plait line off to my C/L...
The Tech Rep commented that he thought the added heat was from the clutch plates but I didn't get further into it than that comment. Hoping we see...
Thanks. I think we are in pretty good shape. There was some small visible corrosion on the clutches and the Tech thought there might be some...
If memory serves yes. Although now that I think about it I believe there is a small H/E for the power steering system after the gear cooler. But I...
On mine, the oil cooler is last in line before the water discharges the boat. We found coolers that are nearly identical. Same diameter and...
The Twin Disc Rep that we used said these gears are as bullet proof as they come. He said that is one reason it is hard to get parts. The demand...
Thought I would follow-up on this. I used the boat for the rest of last season and had no problems with the Stbd trans. However, it continued to...
I have similar DDEC controls but not the series III. I would check the Fire suppression system first as suggested by Capt J. If that checks out...
I have the exact set-up you are describing. I have an ac powered shallow well type pump with pressure tank as primary. Then I have a back-up dc...
We did my 12v92's (just 2(ea) 6v92's inline) in the boat and I have no access hatches over the engines and minimal overhead clearance. We removed...
I had my flybridge enclosure done last winter. I went with the heavy weight Stamoid. I agree with Capt J and the Stamoid can be a challenge to...
I have a Yamaha and it has been great. Certainly can't wrong with a Honda either. I also have a friend with one of the newer Champions and he...
I have 12v92's TTA at 1,050 hp each. Not sure which model/hp 12v92's you are looking at. I have traditional props so can't speak to the jet drives...
I can start them in winter without heat but don't unless necessary. When I shipped the boat up it was unloaded from Transport ship in February. No...
My 12v92's have the heaters toward the front of the motors. both heaters are inboard side just above the stringer rails. They are about the size...
