After 35 years, the windows on our old Bertram is showing it's wear. Vertical etches are on all the exposed sides of all of the windows. Mother...
A 6 inch radar lift. Think a hand full of companies make them. Predrilled for the make of your dome or pedestal. Unless your good at...
Hopefully Not in Heels...
Fire controll relay box? Uh? The only relay should be a NC on the run solenoid. Two for the fuel pump confuses me. Just tie the NC wires...
Always wondered if a translate option was available. Where is it? ,rc
You can not hurt an old Bertram. Picture copied from an interesting Bertram history web page; Tapped out the wheels and back in.
Sounds like a Sales Pitch to me. I would also think the parking lot surface (concrete) would be damaged.
Just curious; Were you hired because you have a 100ton ticket? ,rc
Please scratch my first comments. Thought it was da flat top.
That would take a lot of turning to charge our 12v71s. The switches in our 1978 Bert will not allow a prelube to happen, almost by design....
If a purchasers engine surveyor gives you old junk yard advice on starting your wore out motor and in the same breath give you a good engine...
Is this Genny the old 4 cylinder flat top or the newer V2 Kawasaki motor? The Mag I mentioned is the Magneto from the ole flat top design.
My first thought would have been some issues & repairs with the side doors during her first deployment, then maybe the follow up warranty work....
Can anybody please offer an English summery?
The 6.5 gas model used a brass screen for the air filter/flame arrester. I remember the oil pressure switch mounted low and maybe hard to see...
She was here at Huckins in a covered slip for a while. Then moved to Lambs. She is pretty.
Yep, stated before;
I'm not familiar with the Pertronix kits you refer to but I have been here. Long ago I learned the total advance and curve must be observed per...
Thread sealant is important also. You want a good metal to metal contact for bonding but need a leak proof sealant. Teflon tape has become a...
Please involve a reliable surveyor on these matters. You CAN NOT insert brass with anything below the water line... Bonded bronze or Marelon only....
.jpg&contenttype=jpeg "Click for Abeking")