The results would be amazing using traditional compound, traditional swirl mark remover or finesse, and traditional wax over using just a...
If the doors on the other side are water tight, it's ok to leave it open. But, I still wouldn't think it's too wise to leave it open. If a wave...
He surveyed a 68' Azimut MY that I managed and maintained about 5 years ago. He left the boat and left the entire boat tore up. Every piece of...
I worked on one briefly a while ago, and it appeared to be built fairly well structurally. However, whoever did the engineering for the boat...
If the rollbar is stainless and was welded, it will always have re-occuring rust stains because of the welding. When Stainless steel is welded,...
If you know how to properly use a buffer, you should never get swirl marks. I never do. Swirl marks are usually from using too much speed, doing...
My statement didn't say for the yacht owner to crank the rpm speed up or down. I was explaining that the factory could change the generator rpm's...
Their website does not say. But it's the "whink rust stain remover" in the medium brown bottle
The hull is unfaired and very commercial looking......with the welds and plates showing so much
To answer your question about frequencies. Europe uses 50hz for their electricity. The US and CANADA use 60 hertz. They're not interchangeable....
They'll get what they deserve somewhere down the line. Do that in some of those smaller islands in the Carribean and they'll end up getting...
MASE generators run diesel Yanmar's and are run at 3600rpms and 3000rpms for 60 and 50hz. Fisher Panda also run's those rpm's on a lot of them. I...
This is very common on a lot of the smaller generators......I think they do 2100rpms and 1800rpm's on some of them as well to get the different...
It looks like steel fragments have gotten on, into the paint. Do you have galvanized anchor chain and was the windless used recently? Has it...
I would think the wax would lift the Nano. But that's my opinion and I know nothing about Sea Shield, and their chemists or engineers would know...
FYI, Atlantis has been a royal pain about letting people into their slips before 1pm. Sometimes they have let them in as early as 11am, but...
I knew of a 1987 41' Viking SF that up until 2005, had never ever been compounded and had been religiously been hand waxed every 3 months since...
I have never, and I mean ever, seen FOG between Ft. Lauderdale and Nassau. However, heavy rain is a good possibility depending on the time of year :)
Wasn't this the boat that was built in AL, then sat at ACY in Stuart for a year or two and they did her entire interior?
Are you kidding? Oxidation in a month's time? I have several boats, yachts that are at least 5 years old, sit in direct sunlight every single...
